[nflug] hardware issue

[Justin Bennett]

Slot 1 is the old PIII style? I might have one in the back in an old server.

Justin Bennett
Network Administrator
Dynabrade, Inc.
8989 Sheridan Dr.
Clarence, NY 14031
 



On 2/16/2006 2:42 PM, Frank Kumro wrote:

>does anyone have a slot 1 termination card that I could possibly use
>because to run a single processor I need one of those cards. Or if
>anyone would like to make a couple bucks and sell me one...either way
>i need one. I tested the memory and its fine the only thing plugged in
>is
>Ram,
>Both Proc,
>and of course power supply
>
>yet it still wont enter the setup when i press f2...still says
>entering setup but no go
>
>On 2/15/06, Frank Kumro <fkumro at gmail.com> wrote:
>  
>
>>I will try these options tomorrow when I have some free time. Thanks again!
>>
>>On 2/15/06, may pre house the seamy side volitation <wpos2 at adelphia.net> wrote:
>>    
>>
>>>I would try switching the processor slots.  The only reason that I can
>>>think for this is that maybe the resistance in one of the pins of one of
>>>the processors, however minute, is just enough in the MB circuitry to
>>>throw it off.  Switching them around may put that pin on a more friendly
>>>circuit.
>>>
>>>Forgive my ignorance of dual-proc setups, but can you run just one
>>>processor?  If you have the ability of trying each processor in each
>>>slot, then the results may tell you something.
>>>
>>>Then of course there's the old adage of starting with the bare basics
>>>and adding stuff (I'm thinking of the SCSI card) until the system fails.
>>>
>>>Użytkownik Frank Kumro napisał:
>>>      
>>>
>>>>I just recieved my Intel L440GX+ motherboard and I have two p3
>>>>processors for it. The ram, processors and everything else has been
>>>>installed and the computer powers on. The intel server screen appears
>>>>and i press f2 to enter setup. It says entering setup...thens shows
>>>>the adaptec scsi speal then refreshes to a blank screen. Then
>>>>nothing...no setup. I cleared the CMOS using the jumpers ... also if I
>>>>boot without entering setup it has an error with non matching FSP of
>>>>the processors (which are the same and has run in a dual config
>>>>before). Any ideas? Im lost and would really like to get this machine
>>>>up and running...
>>>>
>>>>thanks again guys!
>>>>
>>>>--
>>>>Frank
>>>>Shenanigans!!
>>>>_______________________________________________
>>>>nflug mailing list
>>>>nflug at nflug.org
>>>>http://www.nflug.org/mailman/listinfo/nflug
>>>>
>>>>        
>>>>
>>>_______________________________________________
>>>nflug mailing list
>>>nflug at nflug.org
>>>http://www.nflug.org/mailman/listinfo/nflug
>>>
>>>      
>>>
>>--
>>Frank
>>Shenanigans!!
>>
>>    
>>
>
>
>--
>Frank
>Shenanigans!!
>  
>
>------------------------------------------------------------------------
>
>_______________________________________________
>nflug mailing list
>nflug at nflug.org
>http://www.nflug.org/mailman/listinfo/nflug
>  
>
_______________________________________________
nflug mailing list
nflug at nflug.org
http://www.nflug.org/mailman/listinfo/nflug