[nflug] hardware issue

[Frank Kumro]

I will try these options tomorrow when I have some free time. Thanks again!

On 2/15/06, may pre house the seamy side volitation <wpos2 at adelphia.net> wrote:
> I would try switching the processor slots.  The only reason that I can
> think for this is that maybe the resistance in one of the pins of one of
> the processors, however minute, is just enough in the MB circuitry to
> throw it off.  Switching them around may put that pin on a more friendly
> circuit.
>
> Forgive my ignorance of dual-proc setups, but can you run just one
> processor?  If you have the ability of trying each processor in each
> slot, then the results may tell you something.
>
> Then of course there's the old adage of starting with the bare basics
> and adding stuff (I'm thinking of the SCSI card) until the system fails.
>
> Użytkownik Frank Kumro napisał:
> > I just recieved my Intel L440GX+ motherboard and I have two p3
> > processors for it. The ram, processors and everything else has been
> > installed and the computer powers on. The intel server screen appears
> > and i press f2 to enter setup. It says entering setup...thens shows
> > the adaptec scsi speal then refreshes to a blank screen. Then
> > nothing...no setup. I cleared the CMOS using the jumpers ... also if I
> > boot without entering setup it has an error with non matching FSP of
> > the processors (which are the same and has run in a dual config
> > before). Any ideas? Im lost and would really like to get this machine
> > up and running...
> >
> > thanks again guys!
> >
> > --
> > Frank
> > Shenanigans!!
> > _______________________________________________
> > nflug mailing list
> > nflug at nflug.org
> > http://www.nflug.org/mailman/listinfo/nflug
> >
> _______________________________________________
> nflug mailing list
> nflug at nflug.org
> http://www.nflug.org/mailman/listinfo/nflug
>


--
Frank
Shenanigans!!
-------------- next part --------------
_______________________________________________
nflug mailing list
nflug at nflug.org
http://www.nflug.org/mailman/listinfo/nflug