[nflug] hardware issue

[David J. Andruczyk]

--- Frank Kumro <fkumro at gmail.com> wrote:

> I just recieved my Intel L440GX+ motherboard and I have two p3
> processors for it. The ram, processors and everything else has been
> installed and the computer powers on. The intel server screen appears
> and i press f2 to enter setup. It says entering setup...thens shows
> the adaptec scsi speal then refreshes to a blank screen. Then
> nothing...no setup. I cleared the CMOS using the jumpers ... also if
> I
> boot without entering setup it has an error with non matching FSP of
> the processors (which are the same and has run in a dual config
> before). Any ideas? Im lost and would really like to get this machine
> up and running...
> 
> thanks again guys!
> 

Try booting it with only 1 CPU installed.  Then swap CPU's,  note any
difference.  do the same with RAM,  It's possible that a component got
zapped with static electricity from handling.  Take all static
precautions as well, as wintertime dry air = lots of electrical part
frying static.




Dave J. Andruczyk

__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com 
_______________________________________________
nflug mailing list
nflug at nflug.org
http://www.nflug.org/mailman/listinfo/nflug