Server Crash again

[Justin Bennett]

Thanks Anyways :)

Cyber Source said:
> I don't have any pga478 cpu's around
> On Fri, 2003-01-24 at 08:47, Justin Bennett wrote:
>> It's a Dual Pentium 4 Xeon (1.8Ghz) system on a Supermicro board,
>> don't know if you have those laying around. Gonna try a new power
>> supply got one on order, didn't think of the processors. It's brand
>> new Ordered it in Nov, just installed last weekend.
>>
>> Thanks
>> Justin
>> Cyber Source said:
>> > It's been my experience with that symptom that it was the cpu going
>> bad, not just getting hot. Try replacing the cpu if you can. What
>> style CPU? I may have one around here you could use to try it before
>> you buy a new one. Let me know. Peter
>> >
>> > On Fri, 2003-01-24 at 07:25, Justin Bennett wrote:
>> >> Hmm. I disbaled the warning temp, was set at 85C. It was running
>> fine for a day and a half I figure I had it worked out. It did it
>> again yesterday afternoon. I have a new Powersupply on order, we'll
>> see what that does. If it still does it then it's going back. I
>> don't have a speaker hooked up so I don't know it it's beeping or
>> not.... hmmm....
>> >>
>> >> > FWIW dpt:  I've got a dual Super P6D?? ... ummm... well anyway,
>> it's
>> >> an older board, dual 600 PIII max, IIRC, but EVERY TIME I enabled
>> the thermal sensor, the thing would beep every few
>> >> > seconds no matter what threshold I set the temp. to.  I finally
>> just
>> >> disabled the bios setting for it.  As near as I could tell, the
>> temp never exceeded 30 C anyway.  And it ran 24/7 for 2 years,
>> until I upgraded.  Trivial, but as you also have a Super boardbeing
>> weird, I wonder if it's more than just coincidence.
>> >> >
>> >> > -Greg
>> >> >
>> >> > On 21 Jan 2003 at 14:59, Justin Bennett wrote:
>> >> >
>> >> >>
>> >> >> Ok for all of you who replied to my earlier message, had it go
>> down
>> >> again today. The odd thing is  I had a top going at the time and it
>> was up 1 day and 6 minutes. So it's almost exactly the same  time
>> it went down yesterday. The power supply and motherboard were
>> installed this weekend to  upgrade a Redhat 7.2 samba file server.
>> It ran all weekend fine, then did this yesterday and  today. Could
>> this be a redhat 7.2 hardware issue? It's a super micro SUPER
>> P4DCE+Motherboard.
>> >> >>  WIth dual p4 xeons on it. It could be a faulty Power supply but
>> >> it's
>> >> >> strange that it's almost the  same time. The power supply needed
>> to
>> >> be unplugged and turned on and off a few times until it  came back
>> on. So it was like it faulted. Ideas, swapping the PS is probably
>> the next step.  However it is a new MB and processor there might be
>> redhat 7.2 issues with this.
>> >> >>
>> >> >> Justin
>> >> >>
>> >> >>
>> >> >> --
>> >> >> -------------------------------------------
>> >> >> Justin Bennett
>> >> >> Red Hat (Linux) Certified Engineer
>> >> >> Network Administrator
>> >> >> Dynabrade Inc.
>> >> >> 8989 Sheridan Dr
>> >> >> Clarence, NY 14031
>> >> >> 716-631-0100 ext 215
>> > --
>> > Cyber Source <peter at thecybersource.com>
> --
> Cyber Source <peter at thecybersource.com>


-- 
-------------------------------------------
Justin Bennett
Red Hat (Linux) Certified Engineer
Network Administrator
Dynabrade Inc.
8989 Sheridan Dr
Clarence, NY 14031
716-631-0100 ext 215