Server Crash again

Justin Bennett Justin.Bennett at dynabrade.com
Fri Jan 24 07:25:42 EST 2003


Hmm. I disbaled the warning temp, was set at 85C. It was running fine for
a day and a half I figure I had it worked out. It did it again yesterday
afternoon. I have a new Powersupply on order, we'll see what that does. If
it still does it then it's going back. I don't have a speaker hooked up so
I don't know it it's beeping or not.... hmmm....

> FWIW dpt:  I've got a dual Super P6D?? ... ummm... well anyway,
> it's an older board, dual 600 PIII max, IIRC, but EVERY TIME I
> enabled the thermal sensor, the thing would beep every few
> seconds no matter what threshold I set the temp. to.  I finally just
> disabled the bios setting for it.  As near as I could tell, the temp
> never exceeded 30 C anyway.  And it ran 24/7 for 2 years, until I
> upgraded.  Trivial, but as you also have a Super boardbeing weird, I
> wonder if it's more than just coincidence.
>
> -Greg
>
> On 21 Jan 2003 at 14:59, Justin Bennett wrote:
>
>>
>> Ok for all of you who replied to my earlier message, had it go down
>> again today. The odd thing is  I had a top going at the time and it
>> was up 1 day and 6 minutes. So it's almost exactly the same  time it
>> went down yesterday. The power supply and motherboard were installed
>> this weekend to  upgrade a Redhat 7.2 samba file server. It ran all
>> weekend fine, then did this yesterday and  today. Could this be a
>> redhat 7.2 hardware issue? It's a super micro SUPER P4DCE+Motherboard.
>>  WIth dual p4 xeons on it. It could be a faulty Power supply but it's
>> strange that it's almost the  same time. The power supply needed to be
>> unplugged and turned on and off a few times until it  came back on. So
>> it was like it faulted. Ideas, swapping the PS is probably the next
>> step.  However it is a new MB and processor there might be redhat 7.2
>> issues with this.
>>
>> Justin
>>
>>
>> --
>> -------------------------------------------
>> Justin Bennett
>> Red Hat (Linux) Certified Engineer
>> Network Administrator
>> Dynabrade Inc.
>> 8989 Sheridan Dr
>> Clarence, NY 14031
>> 716-631-0100 ext 215


-- 
-------------------------------------------
Justin Bennett
Red Hat (Linux) Certified Engineer
Network Administrator
Dynabrade Inc.
8989 Sheridan Dr
Clarence, NY 14031
716-631-0100 ext 215





More information about the nflug mailing list